Electrolux EFI611W84W - Interrupting a Programme and Changing the Options; Cancelling a Running Programme; Opening the Door - Adding Garments

The appliance can play a double beep to
indicate overload or unevenly distributed
load. The tune sounds if acoustic signals
are not disabled.
12.9 Interrupting a programme and
changing the options
When the programme is running, you can
change only some options:
1. Touch the button.
The related indicator flashes.
2. Change the options. The given
information in the display changes
accordingly.
3. Touch the button again.
The washing programme continues.
12.10 Cancelling a running
programme
1. Press the On/Off button to cancel the
programme and to deactivate the
appliance.
2. Press the On/Off button again to activate
the appliance.
Now, you can set a new washing programme.
If the SensiCare phase is already carried
out and the water filling is already
started, the new programme starts
without repeating the SensiCare
phase. The water and the detergent are
not drained out in order to avoid waste.
The display shows the maximum duration
of the programme, updating it about 20
minutes after the starting of the new
programme.
There is also an alternative way of cancelling:
1. Rotate the selector knob to the "Reset"
position .
2. Wait for 1 second. The display shows
.
Now, you can set a new washing programme.
12.11 Opening the door - Adding
garments
At the beginning of the programme or when
delay start operates, you can open the door.
If the temperature and level of the water
in the drum are too high and/or the drum
is still rotating you should not open the
door.
While a programme or the delay start
operates, the appliance door is locked. The
display shows the indicator .
To add or to remove garments:
1. Touch the Start/Pause button.
In the display the related door lock indicator
goes off.
2. Open the appliance door. If necessary,
add or remove the items. Close the door
and touch the Start/Pause
button.
The programme or the delay start continues.
12.12 End of the programme
• The appliance stops automatically.
• The acoustic signals operate (if they are
active).
• In the display comes on.
• The indicator of the Start/Pause button
goes off. The door locked goes off
and the door unlocks.
• Press the On/Off button for some seconds
to deactivate the appliance.
ENGLISH 23