Electrolux EFI611W84W - Cleaning the Inlet Hose and the Valve Filter; Emergency Drain; Frost Precautions

WARNING!
Make sure that the impeller of the pump can rotate. If it does not rotate, contact the
Authorised Service Centre. Make sure also that you tighten the filter correctly to prevent
leakages.
14.10 Cleaning the inlet hose and the valve filter
It is recommended to clean both filters of the inlet hose and valve occasionally to remove
any deposit collected over time.
1
2
3
45°
20°
14.11 Emergency drain
If the appliance cannot drain the water, carry
out the same procedure, described in
"Cleaning the drain pump" paragraph. If
necessary, clean the pump.
14.12 Frost precautions
If the appliance is installed in an area where
the temperature can reach values around 0°
C or drop below, remove the remaining water
from the inlet hose and the drain pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Put the two ends of the inlet hose in a
container and let the water flow out of the
hose.
4. Empty the drain pump. Refer to the
emergency drain procedure.
5. When the drain pump is empty, install the
inlet hose again.
30 ENGLISH