EMS 2390 English
8
1. Remove any promotion label from the door.
2. This oven can be used as a free standing oven or
built-in, into a kitchen cabinet using kit number
MF23 or HK2. To install the oven in a kitchen
cabinet follow the instructions supplied with the
building-in kit.
The oven should be installed on a flat, level surface.
The surface must be strong enough to safely bear
the weight (17.2 kg) of the oven, and the
contents. To avoid the possibility of causing
vibration or noise the oven must be in a stable
position.
3. Keep the oven away from heat and water.
Exposure to heat and water can lower oven
efficiency and lead to malfunctioning, so be sure
to install the oven away from heat and water
sources.
4. Do not block air vents on the top and the sides of
the cabinet and also do not place any articles on the
top of the oven. If air vents are blocked during
operation, the oven may overheat, and this may
lead to malfunctioning. Hot air escapes from the
vents, so be sure not to obstruct it or let curtains
come between the oven and the rear wall.
5. Place the oven as far away from radios and TV’s
as possible. This oven does conform to EEC
requirements of radio interference suppression,
but some interference may occur if it is placed
too close to a radio or TV, so keep them as far
apart as possible.
6. If positioned in a corner, leave a gap of at least
5 cm from the walls and 5 cm above the
microwave.
IMPORTANT! The oven can be placed almost
anywhere in the kitchen. Make sure the oven is
placed on a flat, level surface and that vents as
well as the surface underneath the oven are not
blocked (for sufficient ventilation).
Connecting to the mains
The oven is delivered with the power cord and a plug
for 230–240 V, 50Hz, earthed socket outlet.
Earth protection minimizes the risks should a short
circuit occur. Check to ensure the voltage of the
oven matches the supply.
N.B. If the oven is connected to the socket via an
extension cord, make sure the cord is earthed.
This appliance must not be used on a non-
earth protected power supply. Contact an
electrician if you are uncertain regarding
electrical connection of the oven or
provision of earth protection of the
supply.
This appliance must be earthed. If this
appliance is fitted with a non-rewireable
plug for which your socket is unsuitable, the
plug should be cut off and the appropriate
plug fitted. If it is necessary to change the
fuse in a non-rewireable plug, the fuse
cover must be refitted. If the fuse cover is
lost or damaged, the plug must not be
used until a replacement is obtained.
To Next Page
Loading...
