38
· Check that the mounting brackets are level. They
can be adjusted if necessary by using the extra
holes at the ends of the brackets. Once the
brackets are level, drill a pilot hole through the
central hole in the bracket and fit the remaining
screw.
HOW TO FINISH UNPACKING
· Place packed appliance next to the space in which it
will be installed. See Fig. 8.
· Remove the appliance packing except for bottom
tray which should be left in position until the
appliance is ready to be fitted into its cabinet.
· Ensure the owner is given these operating
instructions.
NOTE: It is imperative that the appliance is left
in the base to protect both the appliance and the
floor.
Fig.8
Important: Switch off at the mains, miniature circuit
breaker and, if appropriate, remove fuse before
commencing any electrical work.
INSTALLATION INSTRUCTIONS
To Next Page
Loading...
