Loading the batteries (use two AAA (1.5V) batteries.
1. Remove the remote control cover.
2. Insert batteries in the compartment, making sure
the and polarities are correctly aligned.
• The display indicates “AM 6:00” when batteries
ar
e properly installed.
3. Reinstall the cover.
NOTES:
• Batteries should last approximately one year
under normal use.
• When you replace the batteries, always change both
batteries, and make sure they are the same type.
• If the remote control does not operate properly after
replacing the batteries, take out the batteries and
reinstall them again after 30 seconds.
• If you will not be using the unit for a long time, remove
the batteries from the remote control.
• Do not use rechargeable batteries.
Using the remote control
Point the remote control towards the unit’s signal receiver
window and press the desired button. The unit generates
a beep when it receives the signal.
• Make sure nothing, such as curtains, block the signal
receiver window.
• The remote control operates from up to 7 metres away.
• Do not expose the signal receiver window to direct
sunlight. This may adversely af
fect its operation.
If necessary, close curtains to block out the sunlight.
• Use of a fluorescent lamp in the same room may
interfere with transmission of the signal.
• The unit may be affected by signals emitted from
other remote controllers for televisions, VCRs or
other equipment used in the same room.
• Do not leave the remote control exposed to direct
sunlight or near a heater. Protect the remote control
from moisture and shock which can discolour or
damage it.
How to use the remote control
remote control
cover
electrolux ESD24HRA & ESD30HRA using the remote control 5
To Next Page
Loading...
