• To clean metal surfaces, use a usual
cleaning agent.
• Clean the appliance interior after each
use. Then you can remove dirt more
easily and it does not burn on.
• Clean stubborn dirt with a special oven
cleaner.
• Clean all accessories after each use
and let them dry. Use a soft cloth with
warm water and a cleaning agent.
• If you have nonstick accessories, do
not clean them using aggressive
agents, sharp-edged objects or a dish-
washer. It can cause damage to the
nonstick coating.
12.1 Steam cleaning
1.
Remove the worst of the dirt manual-
ly.
2.
Put approximately 250 ml of water
and 3 tablespoons of vinegar directly
into the steam generator.
3.
Touch again and again until the
display shows
.
4.
The display shows the duration (15
minutes) and the default temperature.
Touch
to start the cleaning.
5.
An acoustic signal sounds when the
steam cleaning is completed. Touch a
sensor field to stop the signal.
6.
Clean the appliance with soft cloth.
Remove the water from the steam
generator with the sponge and rub it
dry.
Keep the door open for approxi-
mately 1 hour to let the appliance
dry fully.
You can use the End function to
delay the start of the cleaning. Re-
fer to "Setting the END".
12.2 Shelf support
Removing the shelf support
You can remove the shelf support to
clean the side walls.
1.
Carefully pull the support up and out
of the front catch.
2.
Lightly move the support on the front
catch inwards.
36
www.electrolux.com
To Next Page
Loading...
