Electrolux EW30DS75KS - Surface Cooking; Burner Locations and Setup

14
Figure 2
Thecooktopisequippedwithdifferentsized
burners.
The surface burners are located on the cooktop as
follows (See Figure):
- a 5000BTU(natural gas) burner located at the
right rear position;
- a 18000BTU(natural gas) burner located at
the right front position;
- a 9500BTU(natural gas) burner located at the
left front position;
- a 16000BTU(natural gas) burner located at
the left rear position;
- a 9500BTU(natural gas) burner located at the
center position.
Forthe18000BTUburner:
Placetheburnerheadoverthegasorice(Figure
2). Becarefulnottodamagetheelectrodewhile
placingtheburnerheadovertheorice.Make
sureelectrodetscorrectlyintoslotinburnerhead.
Forallburners:
Place a burner cap on each burner head (see
Figure1),matchingthecapsizetotheheadsize.
The cap for each burner has an inner locating
ring which centers the cap correctly on the burner
head.Besurethatalltheburnercapsandburner
headsarecorrectlyplacedBEFOREusingyour
appliance.
Makesureeachburnercapisproperlyalignedand
level.
Turn the burner on to determine if it will light. If the
burnerdoesnotlight,contactaServiceCenter.Do
not service the sealed burner yourself.
Thecoloroftheameisthekeytoproperburner
adjustment.Agoodameisclear,blueandhardly
visibleinawell-lightedroom.Eachconeofame
shouldbesteadyandsharplydened.Adjustor
cleanburnerifameisyellow-orange.Toclean
burner, see instructions under General Care &
Cleaning.
Figure 1
Burner
Cap
BurnerHead
Burner
Cap
Burner
Head
Gas
Opening
Electrode
Surface Cooking
Locations of the burners Placement of burner heads
and caps
Proper burner adjustments