1
30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
P/N 318201615 (0802) Rev. D
English – pages 1-12
Español – páginas 13-24
Français – pages 25-36
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Printed in United States
35 5/8" (90,5 cm) -
36 5/8" (93 cm)
30"
(76,2 cm)
28 5/16" (71,9 cm) 30±1/16"
(76,2±0,15 cm)
21 3/4" (55,2 cm) Min.
22 1/8" (56,2 cm) Max
24" (61 cm) Min. with
backguard
36 5/8" (93 cm) Max.
35 3/4" (90,8 cm) Min.
A. HEIGHT
(Under Cooktop)
B.WIDTH D. TOTAL DEPTH
TO FRONT OF
RANGE
E. CUTOUT WIDTH***
(Countertop
and cabinet)
F. CUTOUT
DEPTH
G. HEIGHT
OF COUNTERTOP
31 1/2"
(80 cm)
C. COOKTOP
WIDTH
Shave Raised
Edge To Clear
Space for
31 1/2"
(80 cm)
Wide
Cooktop Rim.
Grounded Junction Box or Wall Outlet Should Be
Located 8" to 17" (20,3 - 43,2 cm) From Right
Cabinet and 2" to 4" (5,1-10,2 cm) From Floor
24" Min.
(61 cm) Min.
30" Min.
(76,2 cm) Min.
13"
(33 cm)
Locate Cabinet Doors 1" (2,5
cm) Min. From Cutout Opening
Approx. 1 7/8"
(4,8 cm)
18" Min.
(45,7 cm) Min.
30" Min. (see Note 3)
(76,2 cm) Min. (See Note 3)
1 ½" Max.
(3,8 cm Max.)
For existing 29" (73,7 cm) cutout wide opening,
you must call the Service Center for optional
thinner side trims. Also you must prepare the
countertop edge as shown in the "Countertop
Preparation" section (see page 8).
IMPORTANT:
Cabinet and
countertop width
should match the
cutout width.
E
E
These surfaces should be flat &
leveled (hatched area).
Do not install the unit in the cabinet before reading next two pages.
To Next Page
Need help?
General
