18
Start the Washing Program
1. Check that the water tap is open.
2. Start the washing program: Press the button
START/PAUSE (Marche/Pause). The washing
program is started or it starts after the set time
expires.
3
If the indicator DOOR/LIGHT (Tür/Licht,
Porte/Lumiere) lights up red when the button
START/PAUSE (Marche/Pause) is pressed,
the filling door is not correctly closed. Press
the filling door firmly closed and press the
button START/PAUSE (Marche/Pause) again.
If the time preselection is set:
The set time preselection runs and the remaining
time until the program start is shown in the multi-dis-
play (in full hours in each case). During this time you
can load washing or change/abort the time preselec-
tion.
• Load washing: Press the button START/PAUSE
(Marche/Pause). The filling door can be opened.
Next, close the door and again press the button
START/PAUSE (Marche/Pause).
• Change or abort time preselection: Press the but-
ton DELAY TIMER (Zeitvorwahl, Départ Différé) as
often as necessary until the required time is dis-
played; When the program run time is displayed
(shown in minutes, e.g.125), the washing program
starts without delay.
To Next Page
Loading...