To switch off the end of program ‘beep’
The washing machine is factory set to ‘beep’ at the end of
your wash. It will also ‘beep’ when the machine has paused
after the Drip dry Deep rinse, to alert you to remove the drip
dry clothes from the washbowl.
To change the ‘beeping’ selection, proceed as follows:
1. Hold the Start/Pause button depressed for 3 seconds
2. Press the Temp. button to change the selection if
required.
in the digital display = ‘beep’ (ON)
in the digital display = ‘beep’ (OFF)
3. Press the Start/Pause button to store the selection.
When no ‘beep’ at end of program is selected, the machine
will still ‘beep’ when buttons are pressed and for unavailable
selections.
If you do not press Temp. or Start/Pause within 5 seconds
of the last button press or press any other button, the
machine will exit the programming mode. In this case the
setting will not have been changed and the machine will be
paused.
Press and hold
for 3 seconds
22 operating your washing machine electrolux water aid washing machine
If you do not press Water Level or Start/Pause within 5
seconds of the last button press or press any other button,
the machine will exit the auto adjusting mode. In this case
the setting will not have been changed and the machine will
be paused.
Operating your washing machine
Model: EWT806
To Next Page
Loading...
