Electrolux FOM 71 CLS - Temperature, Speed, and Water Adjustment

16:1
Adjustment of temperature, speed and water
FOM 71 MP-Lab
Adjustment of temperature, speed and water
In contrary to Wascator FOM 71 CLS, there is little scope to change or
calibrate the internal parameters of the FOM 71 MP-Lab software.
Temperature:
• Ifthetemperatureofawashprogramistoohighortoolowduringthe
main wash sequence, the temperature sensor must be replaced.
Speed:
• Ifspeedistoolow(washspeedand/orspinspeed),checkincoming
voltage and frequency.
• Ifspeedistoohigh(washspeedand/orspinspeed)checkincoming
voltage and frequency. Also check to see whether the V-belt is exhibit-
ing signs of excessive wear. Changing to a new V-belt will/may reduce
the speed somewhat.
Water:
• Forleveladjustment,seeChapter13.
• Forowmeteradjustment,seeChapter17.