Step 3 Pull the rear end of the shelf
support away from the side wall
and remove it.
Step 4 Install the shelf supports in the
opposite sequence.
The retaining pins on the tele‐
scopic runners must point to the
front.
12.3 How to use: Aqua Clean
This cleaning procedure uses humidity to remove remaining fat and food particles from the
oven.
Step 1 Pour water into the cavity embossment: 300 ml.
Step 2
Select: / . Press: .
The function works for 30 min.
When the cleaning ends the signal sounds. The oven turns off.
Step 3 Wait until the oven is cold. Dry the cavity with a soft cloth.
12.4 How to clean: Water tank
Step 1 Turn off the oven.
Step 2 Place a deep pan below the steam inlet.
Step 3 Pour water into the water drawer: 850 ml. Add citric acid: 5 teaspoons. Wait for 60
min.
Step 4 Turn on the oven and set the function: Humidity Low. Set the temperature to 230 °C.
Turn off the oven after 25 min and wait until it is cold.
Step 5 Turn on the oven and set the function: Humidity Low. Set the temperature between
130 and 230 °C. Turn off the oven after 10 minutes and wait until it is cold.
To prevent limestone residue empty the water tank after each steam cooking.
109/320
CARE AND CLEANING
To Next Page
Loading...
