To Next PageTo Next PageWhat to do if my Electrolux Refrigerator is failing to defrost?
If your Electrolux Refrigerator is failing to defrost, it could be due to a couple of reasons. First, the defrosting heater might be interrupted, in which case you should replace the heater. Second, one or both switches of the thermal protectors could be open, requiring you to replace the thermal switches assembly.
Why is there water leaking inside my Electrolux REFRIGERATION freezer compartment?
If you notice water leaking inside the freezer compartment of your Electrolux Refrigerator, it's likely that the rubber valve is obstructed by foreign bodies. To resolve this, clean the valve under running water or replace it.
General| Brand | Electrolux |
|---|---|
| Model | REFRIGERATION |
| Category | Refrigerator |
| Language | English |
Details air box controls (temperature, LEDs, door) and the ERF550 electronic board.
Identifies key components within the cooler compartment, including the air box.
Details the cooler temperature sensor and the air box contents like fan and door switch.
Explains the air box fan's characteristics and the cooler door switch function.
Details components of the freezer compartment, including cold module fan, heater, and evaporator.
Explains freezer fan, defrosting heater, and thermal switches, including their specifications.
Identifies the compressor, connector box, and connectors within the compressor compartment.
Explains normal operation, temperature regulation, and behavior during first startup/power failure.
Details the automatic defrosting process, including timing and component control.
Illustrates the decision logic for initiating the defrosting cycle.
Describes symptoms and behavior when the cooler temperature sensor fails.
Provides steps to access the battery evaporator and its components in the freezer.
Details the procedure for replacing the thermal switches, including connector detachment and wiring.
Outlines steps to remove the air box to access internal components like PCB, fan, and lamp.
Identifies the compressor and connector box within the compressor compartment.
Explains causes of water leakage and cleaning procedures for the drain hose valve.
Lists possible causes for failed defrosting and how to test the heater and thermal switches.
Describes the steps to initiate a manual defrosting cycle using control buttons.
Explains the meaning of various LED patterns, including normal operation and faults.
