OPERATING INSTRUCTIONS | SMART LINE | BOILING PAN
EN | 02-2015 DOC.N
O
: ST09184-02 23
13.8 COOLING
(if the jacket cooling option has been selected)
BOILING
BOILING/HOT KEEP
BOILING/COOLING
COOLING
• Conrm the selected optionby pressingMenu
forwards once.
• Repeatstep1.
The following text appears in the display (if the
mat temp sensor option has been selected):
COOLING
SET TEMPERATURE
XXX°C
• PressIncreasevalue and the cooling temper-
ature increases (hotter).
If “_ _” appears this means unlimited cooling (the
only option without mat temp. sensor).
• PressDecreasevalue and the cooling tem-
perature decreases (colder).
• Repeatstep4.
The following text appears in the display:
COOLING
-h --min XXX°C
WATER XXX+XXX
AGITATOR 000rpm
When this appears in the display, the machine can
be started by:
19. Pressing START .
The cooling starts now (if the mat temp. sensor op-
tion has been selected). When the correct cooling
temperature has been reached, the red LED goes
out, a buzzer sounds for 2 minutes and the display
flashes until the pan switches off.
To continue cooling towards the adjusted temper-
atu re:
Press START (SV6I/SP6I only).
The following text appears in the display:
BOILING
-h --min XX°C
WATER XXX+XXX
AGITATOR XXXrpm
Switch off the pan by:
20. Pressing STOP .
When the countdown to start is ready or if delayed
start is not selected, the following text appears in
the display:
BOILING/COOLING
Xh XXmin XXX°C
WATER XXX+XXX
AGITATOR XXXrpm
If the boiling pan does not heat up, see error mes-
sages on page 20.
Boiling time starts when the set temperature has
been reached.
When the boiling time is over, the heating switches
off and the pan switches to cooling. The agitator
starts to rotate at a speed of 25 rpm if it has not
been deselected.
The following text appears in the display:
BOILING/COOLING
XX°C
WATER XXX+XXX
AGITATOR 025 rpm
When the correct cooling temperature has been
reached, the red LED goes out, a buzzer sounds
for 2 minutes and the display flashes until the pan
switches off:
The following text appears in the display:
BOILING
-h --min XX°C XX°C
WATER XXX+XXX
AGITATOR 025 rpm
To continue cooling towards the adjusted
temperature:
Press START (SV6I/SP6I only).
Switch off in the following way:
18. Press STOP .
For unlimited cooling:
Switch off the pan manually in the following way:
Press STOP .
The following question appears in the display:
INTERRUPT?
YES PRESS STOP
NO PRESS START
• PressSTOP , the red LED goes out.
SV6I/SP6I only.
After STOP the boiling pan will empty the refriger-
ant. Do not turn off the machine while draining is
progressing (approx. 3 minutes).