DELICATE (Schon) function
7
654321
For especially gentle drying of sensitive fab-
rics with the
care label and for tempera-
ture-sensitive textiles (e.g. acrylic, viscose).
Programme is executed with reduced heat.
Delicate function is only suitable for use with
loads of up to 3kg.
To activate it:
1. Choose the drying programme.
2. Press DELICATE (Schon) button (1) - the
LED above is on.
To deselect function press again DELICATE
(Schon) button (1). The LED above is off.
SENSITIVE (Sensitiv) function
For gentle drying of fabrics that are frequently
worn. Programme starts on full heat setting,
which is then reduced as the programme
progresses to be kind to the washing.
To activate it:
1. Choose the drying programme.
2. Press SENSITIVE (Sensitiv) button (2) -
the LED above is on.
To deselect function press again SENSITIVE
(Sensitiv) button (2). The LED above is off.
The DELICATE (Schon) and SENSITIVE
(Sensitiv) functions cannot be selected
together.
LONG ANTI-CREASE (Knitterschutz
Plus) function
This function prolongs anti-crease phase
what gives 90 min. in total. The drum rotates
in intervals during this phase. The laundry
thereby remains relaxed and free of creases.
To activate it:
1. Choose the drying programme.
2. Press LONG ANTI-CREASE (Knitter-
schutz Plus) button (3) - the LED above is
on and display shows the following icon
.
If this additional function is selected, the anti-
crease phase at the end of the drying cycle
is lengthened by 60 minutes. The laundry can
be removed at any time during the anti-
crease phase.
To deselect function press again LONG AN-
TI-CREASE (Knitterschutz Plus) button. The
LED above is off and 90 from the icon dis-
appears
.
BUZZER (Signal) function
The appliance is supplied with the BUZZER
(Signal) function deactivated.
The buzzer sounds or plays a tune when ac-
tivated during:
–cycle end
– anti-crease phase and when phase starts
or ends
– cycle interruption by a warning
–alarm
To activate it:
1. Choose the drying programme.
2. Press BUZZER (Signal) button (4) - the
LED above is on.
To deselect function press again BUZZER
(Signal) button (4). The LED above is off.
TIME (Zeitwahl) function
To select the programme duration after set-
ting the TIME PROGRAMME (Zeitprog-
ramm) . You can select a programme dura-
tion from 10 mins to 3 hrs in 10-minute steps.
1. Turn the programme knob to the TIME
PROGRAMME (Zeitprogramm). The
blinking 10' appears in the display. (cor-
responding to the cooling phase).
2. Press the TIME (Zeitwahl) button (5) re-
peatedly until the desired programme du-
ration is shown in the display, e.g.
for
a programme of 20 minutes.
If the programme duration is not selected,
the duration is automatically set to 10 mins.
DELAY START (Zeitvorwahl)
With the DELAY START (Zeitvor-
wahl) button (7), you can delay the
start of a programme by between 30
minutes (30') and a maximum of 20
hours (20h).
1. Select the programme and additional
functions.
2. Press the DELAY START (Zeitvorwahl)
button (7) as many times as necessary
until the required start delay appears on
10 electrolux
To Next Page
Loading...
