Electromed WellnessPro + - Technical Specifications; Device Specifications Overview

© 2018 Electromedical Technologies, Inc. Phoenix, AZ USA. Any use of editorial, pictorial or layout composition of this publication without express written consent from Electromedical Technologies,
Inc. is strictly prohibited. This publication was written, illustrated and prepared for print by Electromedical Technologies, Inc
11
Technical specifications:
Number of output channels:
2 (A and B)
Output (both channels)
Waveform 1
“Continuous
mode”
Continuous symmetrical biphasic pulse.
Waveform 2
“Spectrum mode”
Amplitude modulated (ramp up) symmetrical biphasic pulse
with duration of 3 seconds and pause of 1 second in between.
Waveform 3
“Burst mode”
Continuous symmetrical biphasic pulse with duration of 3 – 3.5
seconds and pause of 0.5 – 1 second in between. “Burst”
wave type.
Waveform 4
“Sweep mode”
Amplitude modulated (ramp up – ramp down) symmetrical
biphasic pulse with duration of 4 seconds.
Waveform 5
“Duplex mode”
Combination of wave types 2 and 3.
Continuous symmetrical biphasic pulse with segment durations
of 3 seconds and pause of 1 second.
Voltage
max. voltage AC ~ 35 V;
12 V Peak into 1000-Ohm Load, Max. current 12 mA
Frequency range
0.1 – 10000 Hz
Modes of Operation (both channels)
Continuous
1-10000 pps
Burst
1-10000 pps
Amplitude
modulated
1-10000 pps
Duration (Variable)
1 to 60 minutes per frequency
Treatment Timer
Fully customizable. Increments of 1 minute
Power Requirements
Medical power adapter ONLY
Input:
100-240 V~, 50-60Hz, 0.2A
Output:
7.5 V DC, 2500 mA
Physical Dimensions
Size
11 7/8” W (29 cm) x 3” H (7.7cm) x 7” D (17.7cm)
Weight
2.5 lbs (1.1 kg)
Shipping Weight
(unit only)
3.0 lbs (1.3 kg)