Electromed WellnessPro + - Waveform Descriptions; Continuous and Pre-modulated Modes

© 2018 Electromedical Technologies, Inc. Phoenix, AZ USA. Any use of editorial, pictorial or layout composition of this publication without express written consent from Electromedical Technologies,
Inc. is strictly prohibited. This publication was written, illustrated and prepared for print by Electromedical Technologies, Inc
8
Waveform descriptions:
WellnessPro 2010 Plus has 2 Modes of waveforms:
Continuous and Pre-modulated
Continuous mode produces a continuous train of impulses. The stimulation parameters are not automatically
interrupted nor varied in any way. The continuous mode is quite versatile because it may be applied with a
variety of rate settings.
Variation of continuous mode looks like this:
3 - 3.5 sec 3 - 3.5 sec0.5-1 sec 0.5-1 sec
This variation shows the same continuous mode with a continuous train of impulses (3-3.5 sec) with a small
pause (0.5-1 sec) in between.
Pre-modulated mode produces an amplitude-modulated impulse (Output power is modulated while the
frequency remains the same).
Variation amplitude-modulated mode looks like this:
3 sec 3 sec1 sec 1 sec