© 2018 Electromedical Technologies, Inc. Phoenix, AZ USA. Any use of editorial, pictorial or layout composition of this publication without express written consent from Electromedical Technologies,
Inc. is strictly prohibited. This publication was written, illustrated and prepared for print by Electromedical Technologies, Inc
27
Operating instructions:
You can use your WellnessPro+
®
unit to run the following:
Auto Codes
Single Codes
Custom programs
Custom frequencies
NOTE: The method of usage is a matter of convenience and personal preference.
NOTE: To complete any of the following examples your unit must be plugged in, turned on and must be in
READY mode.
NOTE: For the complete list and single code description please see pages 59-60.
Turning unit ON
Press and hold button for 2-3 seconds
Turning unit OFF
Press and hold button for 2-3 seconds
Note: To turn off the WellnessPro+, unit has to be in READY mode.
Screen appearance
During the startup sequence, welcome screen will be shown and audio melody will be heard.
After the startup melody is complete, the WellnessPro+ will go to standard “READY” mode, screen will be
YELLOW and will look like this:
FLUX: on Multi AUTO: on
WellnessPro PLUS
Ready
To Next Page
Loading...