28
ADDRESSES 128 – 131: SYSTEM PARAMETERS
These addresses offer a number of options for each sub-system. The keypad tones (beeps) and one-key
arming feature for each sub-system can be set at these addresses. Program only system 1 for
unpartitioned systems.
128 First Digit: Keypad Arming/Disarming Tones for System #1
Each sub-system’s keypads can be programmed to beep during arming, disarming and during
the entry delay. Select the keypad tones for system #1 from the table below.
First digit value:
Arm Beep Continuous on Entry Disarm Beep Value
No 0
No No 1 1
3 2
Yes No 3
No 4
1 No 1 5
3 6
Yes No 7
No 8
3 No 1 9
3 A
Yes No B
No C
Continuous No 1 D
3 E
Yes No F
Second Digit: Display, Power Trouble Tones and One Key Arming for System #1
The second digit of this address offers options for the display type of each sub-system’s
keypads and the tones sounded for power related trouble conditions. One-Key Arming allows
the user the capability to arm the system, using either the STAY or AWAY keys, without
needing to enter a user code. Select these options for system #1 from the table below.
Second digit value:
Display
Type
One Key
Arming
Beep for
AC Loss
Beep for
Low Battery
Value
No No 0
Disabled Yes 1
Yes No 2
Summarized Yes 3
No No 4
Enabled Yes 5
Yes No 6
Yes 7
No No 8
Disabled Yes 9
Yes No A
Detailed Yes B
No No C
Enabled Yes D
Yes No E
Yes F
129 Same as above for System #2
130 Same as above for System #3
131 Same as above for System #4
To Next Page
Loading...
