Elektro-Automatik PSB 9000 3U Series User Manual

Elektro-Automatik
Doc ID: PSB9EN
Revision: 04
Date: 11/2018
Operating Guide
PSB 9000 3U
Bidirectional DC Power Supply
Attention! This document is only
valid for devices with rmwares
“KE: 2.25” (standard models)
resp. “KE: 2.09” (GPIB models),
“HMI: 2.04” and “DR: 1.6.5” or
higher.

Elektro-Automatik PSB 9000 3U Series Specifications

General

Series	PSB 9000 3U
Number of Outputs	1
Storage Temperature	-20 °C to +70 °C
Input Frequency	50 Hz / 60 Hz
Form Factor	3U
Interface	LAN, USB, Analog
Operating Modes	Constant Voltage, Constant Current, Constant Power
Protection	Over Voltage, Over Current, Over Temperature
Operating Temperature	0 °C to +50 °C
Relative Humidity	5% to 95% non-condensing

Summary

1. GENERAL

1.7 Safety

Crucial safety information, warnings, and precautions for device operation.

1.8 Technical Data

Comprehensive technical specifications, including operating conditions and performance.

1.9 Construction and function

Details on the device's internal components, block diagram, and general design.

2. INSTALLATION & COMMISSIONING

2.3 Installation

Procedures for installing the device, including safety and connection guidelines.

2.3.4 Connection to AC supply

Detailed instructions on how to safely connect the device to the AC power source.

2.3.5 Connection to DC loads or DC sources

Guidelines for correctly connecting DC loads and external DC sources to the device.

3. OPERATION AND APPLICATION

3.3 Operating modes

Explanation of various operating modes like CV, CC, CP, CR, and their characteristics.

3.5 Manual operation

Step-by-step instructions for operating the device using the front panel controls.

3.6 Remote control

Information on how to control the device remotely via digital or analog interfaces.

1.9.6 The control panel (HMI)

1.9.6.1 Touchscreen display

Description of the touchscreen interface, its areas, and operation.

1.9.6.2 Rotary knobs

Explanation of the functions and operation of the device's rotary knobs.

3.11 The function generator

3.11.3 Method of operation

Explanation of how the function generator works and how to set values.

3.11.16 Battery test function

3.11.16.1 Settings for the static discharge mode

Parameters for configuring the static discharge mode in battery testing.

3.11.16.4 Settings for the dynamic test mode

Parameters for configuring the dynamic test mode in battery testing.

3.11.17 MPP tracking function

3.11.17.1 Mode MPP1

Explanation of the "find MPP" mode for solar panel testing.

3.11.17.2 Mode MPP2

Description of the mode that tracks the Maximum Power Point permanently.

3.12 Parallel operation in master-slave (MS)

3.12.1.4 Wiring and set-up of the digital master-slave bus

Steps for wiring and configuring the digital master-slave bus for system setup.

4. Service and maintenance

4.2 Fault finding / diagnosis / repair

Procedures for diagnosing and repairing faults in the device.

4.2.1 Firmware updates

Information and instructions on updating the device's firmware.

5. Contact and support

5.2 Contact options

Information on how to contact technical support for assistance.