Page 6
EA Elektro-Automatik GmbH
Helmholtzstr. 31-37 • 41747 Viersen
Germany
Fon: +49 2162 / 3785-0
Fax: +49 2162 / 16230
www.elektroautomatik.de
ea1974@elektroautomatik.de
PSB 9000 3U Series
1.4 Disposal of equipment
A piece of equipment which is intended for disposal must, according to European laws and regulations (ElektroG,
WEEE) be returned to the manufacturer for scrapping, unless the person operating the piece of equipment or an-
other, delegated person is conducting the disposal. Our equipment falls under these regulations and is accordingly
marked with the following symbol:
1.5 Product key
Decoding of the product description on the label, using an example:
PSB 9080 - 360 3U xxx
US208V = US model for 208 V three-phase supply
Construction (not always given):
3U = 19" frame with 3U
Maximum current of the device in Ampere
Maximum voltage of the device in Volt
Series: 9 = Series 9000
Type identication:
PSB = Power Supply Bidirectional, always programmable
1.6 Intended usage
The equipment is intended to be used only as a variable voltage and current source or only as a variable current sink.
Typical application for a voltage source is DC power supply to any relevant user, including when used as battery
charger to test charge various battery types, and for current sinks the replacement of an ohmic resistor by an
adjustable electronic DC load in order to load relevant voltage and current sources of any type.
• Claims of any sort due to damage caused by non-intended usage will not be accepted
• All damage caused by non-intended usage is solely the responsibility of the operator
To Next Page
Loading...
Need help?
General
