Elektron Analog Rytm - Songs

5. OVERVIEW OF THE ANALOG RYTM DATA STRUCTURE
15
5.2.6 SONGS
16 songs are available for each project. They are used to sequence the playback of patterns. Songs are
built of patterns and chains. Read more about songs in the section “12.2 SONGS” on page 48.
5.2.7 GLOBALS
The GLOBAL settings contain overarching settings for the sequencer, MIDI, and global track routing.
Four global slots are available for each project, each with its own specific settings. Read more about the
global settings in the section “13. GLOBAL MENU” on page 51.
5.3 ABOUT THE TRACKS
5.3.1 THE DRUM TRACKS
There are 12 drum tracks. To select a track for editing, press and hold [TRACK] key and then press one
of the [PADS]. Each drum track uses a specific drum voice controlled by one of the MACHINES available
for the voice. All drum tracks can layer analog percussion sounds and sampled sounds, to distort and
filter them, and apply a dedicated LFO each.
5.3.2 THE FX TRACK
The FX track controls the Analog Rytm send eects DELAY and REVERB, as well as the DISTORTION
and COMPRESSOR master eects. One LFO is also available for this track. To select the FX track for
editing, press the [FX] key.
5.3.3 EDITING THE TRACKS
The five [PARAMETER] keys open parameter pages that are used for editing the tracks. The SYNTH
page of a drum track contains dierent parameters depending on the MACHINE chosen for the analog
percussion sound generator. The other pages are identical for all drum tracks; the SAMPLE page for
the sample playback engine, the FILTER page for the multimode filter and its filter envelope, the AMP
page for the amplitude envelope and eect sends, and the LFO page for the low-frequency oscillator.
The corresponding five parameter pages for the FX track controls the four eects and the FX LFO. Edit
parameters using the DATA ENTRY knobs A-H. Press and turn a knob to adjust its parameter in larger
increments.