Why is the red LED indicator light on my Element LED TV on?
If the red LED indicator light is on on your Element LED TV, it is likely set in standby mode. Press either the POWER button or the Standby button on the remote control to turn it on.
What to do if my Element LED TV is dead but the red LED is lit?
If your Element LED TV is dead but the red LED is lit, it means the TV is in standby mode. Press either the Power button or the Standby button on the remote control to turn it on.
How to improve poor reception on some channels on Element ELCFT262 LED TV?
If you're experiencing poor reception on some channels with your Element LED TV, try tuning to another station, as the station or cable might be experiencing problems. If the station signal is weak, reorient your antenna for better reception. Also, check for any sources of possible interference.
Why does picture appear slowly after switching on Element LED TV?
The image on your Element LED TV is muted during the product start up process. If the picture has not appeared after 5 minutes, please contact a service provider.
What to do if the signal is out of range on Element ELCFT262?
If the signal is out of range on your Element LED TV, adjust the resolution, horizontal frequency, or vertical frequency. Also, check whether the signal cable is connected or loose, and verify the input source.
What to do if screen color is unstable on Element ELCFT262?
If the screen color on your Element LED TV is unstable or a single color, check the signal cable. If the problem persists, try re-installing the PC video card.
General| Screen Size | 26 inches |
|---|---|
| Display Type | LED |
| HDMI Ports | 2 |
| USB Ports | 1 |
| Refresh Rate | 60 Hz |
| Aspect Ratio | 16:9 |
| Built-in Tuner | Yes |
To Next Page
