Element ELGFT401 User Manual

15
Operating Your Television
Audio Menu Options
Press MENU on the front panel or MENU on the remote control and then use / to select the AUDIO
menu, press or OK to enter (see picture below).
1. Use / to select the option you want to adjust
in the Audio menu.
2. Press OK or / to adjust (according to the hints below)
3. When you are satisfied with your adjustment, press MENU
Audio Mode
You can select the type of sound which best corresponds to your listening requirements by selecting
Sound in AUDIO menu.
Balance
Press / and then use / to adjust the audio output between left and right speakers.
Bass
Press / and then use / increase or decrease the level of the lower-pitched sounds.
Treble
Press / and then use / to increase or decrease the level of higher-pitched sounds
Sound Mode
Press / to select one of the modes options: Concert, Jazz, User, Voice
Sound Surround
Press / to switch Surround Sound On or Off
Auto Volume Control
Press / to switch auto volume control On or Off.
s volume to be controlled automatically.
SPDIF
Press / to select between PCM, OFF or RAW
TV Menu Options
Press the MENU on the front panel or MENU on the remote control and then use / to select the TV
menu, press or OK to enter (see picture below).
1. Use / to select the option you want to adjust
in the TV menu.
2. Press OK or / to enter the desired function.
3. When you are done, press MENU to exit.
Tuner Mode
Select the signal input mode: Antenna or Cable
Channel Scan
Select “Channel Scan”; press OK to start the channel scan.
Press MENU to stop or continue until the scan is complete;
Stopping in the middle of a scan will save the
scanned channels up to the stop point.
to exit.
This function allow
75
80
OK

Element ELGFT401 Specifications

General

Brand	Element
Model	ELGFT401
Category	LCD TV
Language	English