AUDIO
RECEIVER
R
L
199
CD PLAYER
Connecting a compact disc player
Using one pair of (red/white) stereo cable,
connect this unit to your compact disc
player correctly.
To play a CD, press CD, select the unit to CD
mode and press PLAY.
NOTE:
The AUDIO SOURCE connection can be
used as input for any stereo audio signal.
12
CONNECTING AUXILIARY COMPONENTS
Before you connect.....
-Protect devices from power surges.
-Connect all devices before plugging power supply
cords into the wall inlet.
-Always turns off the unit and/or other devices
before connect or disconnect any cables.
-Always make sure the color-lighted plugs match
the colour of the terminals in which they are
inserted.
-The connecting cable plugs and jacks are
color-lighted as follows:
Speaker Terminals Red is positive (+) terminals.
Black is negative (-) terminals.
-Some units may supply red and black connecting
plugs insead of red and white. In this case, the
black plug takes the place of the white plug.
of red and white. In this case, the black plug
takes the place of the white plug.
-Insert all cable plugs firmly into the jacks.
-Insert audio/video cables in the back of the
unit.
-Do not coil any power cables and keep them
away from the audio/video cables as far as
possible.
-Make sure all antennas and cables aregrounded
properly.
Review the Safety Tips packed with the unit.
Insert cables correctly to avoid Audio hum
or interference
Connecting the cables
To Next Page
Loading...