Elenberg PRT-9050 - Operating the Air Conditioner; Selecting Modes and Fan Speed; Temperature and Power Settings

Operation instructions
28
Operation modes
1. Selecting mode
Each time MODE button is pressed, the operation mode is changed in sequence:
2. FAN mode
Each time the «FAN» button is pressed, the fan speed is changed in sequence:
At «FAN ONLY» mode, only «High» and «Low» are available. At «DRY»
mode, airflow is set at «Low» automatically, «FAN» button is ineffec
tive in this case.
3. Setting temperature
Press once to raise temperature setting by 1°C (2°F)
Press once to lower temperature setting by 1°C (2°F)
Turning on
Press button, when the appliance receives the signal, the RUN
indicator of the air conditioner lights up.
HEATER (SUPER), SMART, DRY, TIMER ON and TIMER OFF operation modes will be specified in
the following pages.
Changing modes during operation, sometimes the unit does not respond at once. Wait 3 minutes.
Wait 3 minutes before restarting the appliance.
smart
cooling
dry
fan only
Auto
High
Low
unable to set
room temperature ±2°C (4°F)
18°C (64°F) ~ 32°C (90°F)
Range of available set temperature