eClip Full User Guide 14
Changing the eClip Battery
The battery should be good for 500 hours of continuous use. Good battery health is
very important, so we recommend that you replace it at least twice a year: at the start of
summer and the start of winter. Always replace the battery when the eClip Monitoring
screen drops to two red bars.
Once you close the battery cover the eClip‘s red LED flashes quickly three times to indicate
that it is on. It will then continue to flash about once every second.
To change the battery:
Always use a high quality CR2032 battery (Panasonic or equivalent) for
the most reliable results.
The battery cover is tight to prevent young children from opening it.
Caution:
Note:
1. Take the eClip off of the strap where it is installed and turn it over.
2. Take a coin and rotate the battery cover counter-clockwise until it comes off.
3. Take out the spent battery and dispose of it responsibly, as required by your local codes.
These batteries cannot be recharged.
4. Put the new battery in place, with the flat side, marked with a plus sign (+) facing up.
5. Replace the battery cover, turning it clockwise with a coin, until the coin is in line with
the two H-clips.
CR2032
3V
To Next Page
Loading...
