Eliet E401 - Checking and Setting the Depth Control

34
English
• Aftercleaning,replaceallpartsintheiroriginalpositions.
Caution:
In the event the machine has toppled over for some reason, check the air filter
immediately. The unusual position of the engine may have caused oil to seep
from the crankcase via the carburettor onto the air filter. Oil on the filter paper
obstructs the air passage. Soiled filters must be replaced immediately.
11.4.4 Checking and setting the depth control
CORRECT DEPTH SETTING = MAXIMUM EFFICIENCY
Caution:
This maintenance may only be carried out with the engine off
and the blades at full stop.
Warning:
Wear gloves to perform this procedure.
Depth adjustment is carried out by positioning the front
wheels (continuous – stepless -) and the rear wheels (3
positions) of the scarifier.
• Carefullyplacethescarieronanevenandhardsurface.
Make sure that the blades don’t get damaged.
• Removethekeyattherightsideofthepushbracket.
• Loosentheboltoftheleftandrightfrontwheelsslightly .
This is necessary to unlock the depth control.
• Placealevelobjectofapprox.4mmthickunderboth
front wheels.