Eliet E401 - Page 42

42
English
• Repositionthemachineonallfourwheels.
• Tightenthetwobolts(M10)undertheengineplateevenly
until the two free belt parts can be pressed together to
up to 1 cm from each other in relaxed condition.
• Checkthealignmentofthetwobrakedisks.Thebrake
disks are aligned if a slat, held against the brake disks,
touches the four indicated points.
• Ifnecessary,alignmentcanbeadjustedviathenutsun-
der the engine plate. The result must be that the engine
plate is level with the chassis. Make sure not to disturb
the belt tension in the process.
Tilt the scarifier by pushing the handlebar to the ground.
• Tightenbothlocknuts(M10)underthemachine.
• Placethebeltprotectioncover.Whenreplacingthebelt
protection cover, verify that it doesn’t touch the pulley
when the blades are engaged. The slots in the cover
provide some play to avoid contact.
• Repositionthemachineonallfourwheels.