Eliet E401 - Page 44

44
English
Provide support for the blade axle.
• Removethebolts(M8)thatsecurethetwobearinghol-
ders with a ring spanner 13.
• Removethebladeaxle.
For your information:
All original parts are available from your authorised ELIET dealer.
b. Changing the blades
The blades are fed on a hexagonal axle. To replace them, it suffices to remove the bearing at the
pulley end.
Before sliding the bearing from the axle, slightly sandpaper the tip of the axle to remove any
burrs or dirt etc. that may impair easy handling.