Rev. 09042020 www.elitescreens.com
3. ADJUST THE EXTENDING LIMIT (The bottom stop position) Red Limit Screw:
Adjusts the drop of the screen. Rotate the red screw (Figure 03)clockwise to decrease the drop.
One rotation equals one inch of decreased black masking at the top. Do this with the screen in
the open position. Note: You will need to use remote to raise and then lower the screen to see
the adjustment made. The screen will not react as you make this adjustment.
Rotate the DOWN position screw counter-clockwise with the screen in the open position to
make the screen drop lower. In this position, the screen will react and drop in small increments.
Do this only if you do not have the amount of black masking as advertised or are correcting the
initial decreased adjustment.
Be advised that you cannot adjust the drop to change the aspect ratio of the screen. Over adjusting
the limit screws will strip the motor’s internal gears. You can only decrease the black masking.
To Previous Page
Loading...
