© 1999 ELKA-Torantriebe GmbH & Co. Betriebs KG page ES 25, ES 30, ES 40
12
8.2.
Swinging ‘pogo stick’ support for ES 40
a) Close the barrier.
b) Using the screws ‘B’, connect the upper and lower parts in the approximate length.
c) Remove about 500 mm of the rubber tubing under the boom and push the two square nuts ‘A’ into
the slot. Secure it with the two hex. socket screws.
d) Push the rubber tube into the slot and cut off the protruding part.
e) A fine adjustment of the length can now be made on the foot ’D’.
f) Screw an M4 screw into the hole ‘E’.
g) The foot can now be screwed to the appropriate position.
To Next Page
