How to fix a creaking sound during auger rotation in my ELMECO B Large?
If you hear a creaking sound during the auger rotation in your ELMECO Beverage Dispenser, this noise usually comes from the vertical and horizontal auger gears. You can resolve this issue by continuing to use the machine, or by applying some Vaseline to the plastic gears.
Why does the “3” LED blink when I turn on my ELMECO B Large in “slush” mode?
When you turn on your ELMECO Beverage Dispenser in “slush” mode and the “3” LED starts to blink, it means the electronic board is initiating the calibration procedure because the product temperature is above 5°C. This calibration will last about 2 minutes, during which the “3” LED will continue to blink.
How to fix blinking “1” and “slush” LEDs with rotating augers on my ELMECO Beverage Dispenser?
If the “1” and “slush” mode LEDs are blinking on the electronic board of your ELMECO Beverage Dispenser and the augers are rotating, check that the cable connecting the electronic board to the gear motor magnetic revolution counter is firmly attached to both components. If the cable needs replacement, disconnect the old cable's connectors from both the reader and the electronic board, then secure the new cable with insulating tape or a small band on the existing electrical installation.
What to do if led 2 blinks on the electronic board of my ELMECO B Large Beverage Dispenser?
If LED 2 is blinking on the electronic board of your ELMECO Beverage Dispenser, replace the cable that connects the thermostat probe to the electronic board. Ensure there is no oxide on the cable. If oxide is present, clean the contacts. If the problem persists after cleaning, the thermostat probe needs to be replaced.
General| Brand | ELMECO |
|---|---|
| Model | B Large Series |
| Category | Beverage Dispenser |
| Language | English |
To Next Page
