s »Volume« Setting the volume
s »transfer« Programming a default call forwarding number
s »MSN name« Assign a name to the MSN extension number
s »Charge« Programming a charge limitation for a specific extension number
(MSN)
s »PIN« Assign a specific PIN for an externsion number (MSN)
Reset - Resetting to default state
You can reset the telephone to its initial state using the procedure described as follows. All of the data that
you have entered previously will be deleted.
If you have connected the elmeg T400, T400/2 key extension module to your phone all of the data for the
module will also be deleted when this procedure is executed.
Please note: Settings for the answering machine and any texts that have been stored will not be deleted.
Please refer also to the instruction manual supplied with your answering machine.
Begin as follows:
a
Ms s
t
Oss
Configu
-
ration
Service
Telephone
PIN
Data ok
s Press »ok« to reset the telephone to its initial
state. If you do not wish to have the data dele
-
ted press »No«.
Sure to delete all?
No
^ok
¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬
When you press the »ok« softkey, the tele
-
phone is reset to the default state. All data are
deleted.
Which language }
Italiano
Español
Deutsch
English
Française
Nederlands
English
18
To Next Page
Loading...