Foot Control and Sewing Speed
Sewing speed is determined by how hard you press
on the foot control. The harder you press on the foot
control, the faster the machine runs.
IMPORTANT: Before using your sewing machine
the first time, place waste fabric under the
presser foot and run the machine without thread
for a few minutes. Wipe away any excess oil.
Removing the Bobbin Case
Remove extension table and open the bobbin cover.
Hand turn the flywheel toward you to raise the
needle. Pull out the latch to remove the bobbin case.
Release latch. Drop bobbin out of bobbin case.
Spool Pins
Pull up spool pin(s) to place thread spool. Push
spool pin(s) down when carrying or storing machine.
NOTE: If thread tangles under spool A, pass
thread through hole B as shown.
12
(U.S.A.)
A B
To Next Page
Loading...
