Need help?Do you have a question about the ELNA easy cover and is the answer not in the manual?
General| Brand | ELNA |
|---|---|
| Model | easy cover |
| Category | Sewing Machine |
| Language | English |
Procedures for removing and attaching the belt cover using setscrews.
Procedures for removing and attaching the looper cover, including hinge attachment.
Steps to remove and attach the rear cover by manipulating a handle and setscrews.
Steps to remove and attach the front cover after other covers are removed.
Instructions for removing and attaching the free arm cover using setscrews.
Adjust the distance between the presser foot and needle plate to 4.7-5.3 mm.
Set the pressure adjusting screw to protrude 10 mm from the top of the machine.
Adjust the needle bar height to achieve 7.8-8.2 mm clearance.
Set the feed dog height to 0.75-0.95 mm above the needle plate.
Adjust the looper point height to be between 72.6–73.0 mm.
Set the distance between looper point and right needle center to 1.8-2.2 mm.
Time the needle and looper so the needle bar rises 1.3-1.5 mm from lowest position.
Ensure 0-0.05 mm clearance between the looper point and needle scarf.
Set back needle guard height 2.6-3.0 mm below the looper point lower edge.
Time the needle and feed dogs for 2.9-3.1 mm needle point height.
Adjust stitch length to 30-32 mm for 10 stitches.
Adjust differential feed ratio for uniform feed dog movement.
Set tension for left, center, right needle and looper threads.
Procedures for motor replacement and belt tension adjustment.
To Next Page
