24
Inserting the bobbin
z Place the bobbin in the bobbin holder w with the
thread q running off counterclockwise.
x Guide the thread into the notch on the front e of
the bobbin holder.
c Draw the thread to the left, sliding it between
the tension spring blades r.
v Continue to draw the thread lightly until the thread
slips into the notch on the side t.
b Pull out about 10 cm (4˝) of thread to the rear.
Reattach the hook cover plate.
A threading chart y is shown on the hook cover
plate for your reference.
z
x
c
v
b
q
w
e
t
r
t
y
To Next Page
Loading...
