26
3
z Draw the thread from the spool. Hold the upper
thread q at the spool with your finger.
x Slip the thread under the thread guide w from the
right and down along the right channel e.
Be sure that the thread passes between the
tension disks r.
c Then draw the thread around the bottom of the
thread guide plate t.
Raise the presser foot.
Press the Up/Down needle
key to raise the thread
take-up lever to its highest
position.
Threading the Machine
q
c
b
x
v
n
x
c
v
bn
w
e
r
t
y
u
v Firmly draw the thread up along the left channel to
the thread take-up lever y and down into its eye
from the right to the left.
b Then down through the lower thread guide u.
n Slide the thread behind the needle bar thread
guide i on the left.
*Use built-in needle threader to thread the needle.
(see page 28)
i
z
To Next Page
Loading...
