EasyManua.ls Logo

ELNA eXperience 540 - SECTION IV. DECORATIVE STITCHES Shell Tuck; Satin Stitches

ELNA eXperience 540
100 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
74
You can make an embroidery design with this cross
stitch pattern in a half time it would take by hand.
NOTES:
The pattern size can be reduced by pressing
Down (–) key in the stitch width adjusting mode.
If you press the auto lock button before starting to
sew, the machine will sew one unit of the pattern
and stop automatically.
Smocking
Machine setting
q Pattern: #36, #43–#45
w Presser Foot: Satin stitch foot F
e Needle thread tension: 1–4
qwe
q
q
qw e
qw e
Cross Stitch
Machine setting
q Pattern #49
w Presser Foot Satin stitch foot: F
e Needle thread tension: 1–4
Fagoting
Machine setting
q Pattern #41 or #42
w Presser Foot Satin stitch foot: F
e Needle thread tension: 1–4
Fold under 1.5 cm (1/2˝) on each fabric edge and
press. Pin the two edges to a piece of paper 0.3 cm
(1/8˝) apart.
Sew guiding the fabric so the needle catches the
folded edge on each side.
Peel off the paper from fabrics.
Smocking is a delicate, decorative treatment on
children’s clothing or women’s blouses. Choose a soft,
lightweight fabric such as batiste, gingham or challis.
Cut the fabric three times the finished width.
1. Set needle thread tension to 2.5. Use the straight
stitch with the stitch length at 4.0.
2. Sew rows of straight stitches about 13 mm (1/2˝)
q apart, across the area to be smocked.
3. Tie the threads along one edge. Pull the bobbin
threads to gather the fabric and make the gathers
even. Tie the threads at the other end.
4. Turn the stitch selection knob to decorative stitch.
Set needle thread tension to 3.0.
5. Sew the decorative stitch between the straight
stitching lines.
6. Pull out straight stitching lines.

Table of Contents

Related product manuals