71
Warning Sign Cause Try this
The bobbin winder spindle is shifted to the right. Shift the bobbin winder spindle
to the left for stitching.
The machine is halting due to overload. Wait for at least 15 seconds to
restart. Remove tangled threads
around take-up lever, hook race
and automatic thread cutting
mechanism.
The caution message appears when the lockout
key is pressed while the embroidery hoop is at the
position to disturb threading.
The embroidery hoop will
temporaly move to a position
to avoid disturbing a threading
when the OK key is pressed.
The machine is malfunctioning. Contact the service center or the
store from whom the machine
was purchased.
Problems and Warning Signals
If the visual touch screen shows a warning sign, follow the guidance below.
To Next Page
Loading...
Need help?
General
