ELNA Supermatic - Adjusting the Lateral Position of the Guard Ring Stop

30

AdjustingHeightofGuardRingStop.
Theremustbeagapofbetween0.3to0.4mmbetween
GuardRingStopandtheuppersurfaceoftheshuttlehook
whentheThreadReleaseisatitslowestposition.
RemovetheUpperandLowerGuardRingsfromtheshuttle
tomeasurethegap.

Adjustasfollows:
TurnflywheeltowardsyouuntilGuardRingStopreachesits
lowestposition.
LoosenthehexnutontheLifterSkidScrewattherightinside
oftheThreadRelease.(7mmwrench)
TurntheLifterSkidScrewattherightinsideoftheThread
Release.(7mmwrench)
AdjustheightbyturningtheLifterSkidScrewclockwiseor
counterclockwise(asrequired)untilthegapbetweenthe
GuardRingStopandtheuppersurfaceoftheshuttlehookis
between0.3to0.4mmwhentheThreadReleaseisatits
lowestposition.
Usingtwo7mmwrenches,holdtheLifterSkidScrewand
tightenthenut.


