Manuale istruzioni LAVASCIUGA MOD. ZLA40 – ZLA40C – ZLA40CB
8. PUTTING THE MACHINE INTO SERVICE
8.1. Starting Position
The machine has a starting position, from where the operator has the possibility to use all the
machines functions, from switch on to switch off, via the general key ignition. When the
START button is enabled it prepares the motors for function, at its various indicators.
All the commands are shown on the front panel and have been ergonomically positioned to
facilitate use for the operator.
The lever is used to start the cycle.
8.2. Command Panel
As shown in the Fig, on the panel are:
(1): Power button
(2): Brush motor button
(3): Suction motor button
(4): led for state of battery
(5): Light for waste water level (Full)
05/07/11 Rev .0.0 Lavasciuga Mod.ZLA40 – ZLA40C – ZLA40CB
To Next Page
Loading...
