Manuale istruzioni LAVASCIUGA MOD. ZLA40 – ZLA40C – ZLA40CB
9. WORKING PROCEEDURE
1. Follow all the adjustments in the proceeding paragraphs.
2. Make sure you have emptied the waste water tank ( read relevant information on how to
proceed)
Fig 28
3. Make sure you have filled the detergent ,water tank with clean water.
4. Make sure you have attached the appropriate power source: the charger and the battery
connector is the right way, in the case of the battery machine, verify also the state of
battery charge by checking the opposite led; check the plug is inserted into the mains, in
the case of the mains machine.
5. Verify that the knob of the third wheel is unfastened fully anti-clockwise and the brush
has lowered to make contact with the floor.
6. Use the dryers raising lever to lower onto the floor.
7. Power up the machine, using the general ignition switch I/O.
8. Using the detergent adjustment lever, apply the solution to the floor, in order to wet
enough, without forming puddles . and remembering you only need enough to do a bit at
a time, according to the speed and dirtyness of the floor.
9. Switch on the suction motor.
10. Switch on the brush rotation motor.
11. Push the machine to the desired speed, using the handlebars to the direction required.
Fig.29
05/07/11 Rev .0.0 Lavasciuga Mod.ZLA40 – ZLA40C – ZLA40CB
To Next Page
Loading...
