Manuale istruzioni LAVASCIUGA MOD. ZLA40 – ZLA40C – ZLA40CB
10. PROCEEDURE AT THE END OF WORK.
At the end of work you need to follow these points:
1. Bring the machine to rest.
2. Close off the detergent solution using the lever at the front of the brush plate.
3. Switch off the suction motor
4. Switch off the brush motor
5. Shut off all power to the machine, using the general ignition switch I/O.
6. Remove, in the case of the mains cable, the plug from the mains socket.
7. Using the dryers lever to raise it off the floor.
8. Lift the brush plate, going clockwise on the third wheels knob..
9. Push the machine to the place where it is to be emptied.
10. Undo the waste water tube from the tank ( see Fig), open the valve and empty the waste
tank, into a waste water tank collector.
IMPORTANT : This operation must be carried out using protective gloves.
11. Dismantle the brush and clean with a jet of clean water. ( for dismantling read the
dedicated paragraphs)
11. SAFETY PROCEEDURES.
To protect the working area, there is a rubber guard present, around the brush plate, known
as a splash guard or bumper.
All the motors are protected by ampometric fuses, which blow should there be a power
surge.
IMPORTANT : Should the fuses continually blow,the machine should be checked by
one of our technical engineers.
05/07/11 Rev .0.0 Lavasciuga Mod.ZLA40 – ZLA40C – ZLA40CB
To Next Page
Loading...
