9. The meter connections must be completely water tight when
the system is pressurised.
10. Once installed, the meter should not be painted or come into contact
with chemicals such as household cleaning fluids.
11. When making repairs to pipework near to the meter installation,
care should be taken to prevent damage to the meter, especially when
using a heat source.
Health and Safety at Work Act 1974
1. We wish to inform you that in accordance with Section 6 of the
above Act, we take every care, as far as is reasonably practicable
to ensure that our products are safe without risk to health when
properly handled, transported, installed, used, maintained and
disposed. However, as manufacturers and suppliers of a wide
range of products, we would advise you that related information
for these products will be found in the following literature.
• Regulations(suchastheCOSHHRegulations,ManualLifting
Regulations, Personal Protective Equipment Regulations),
British Standards and other applicable ISO and European
Specifications and Codes of Practice, as applicable to the
intended application of the products.
• Regulationsforelectricalequipmentofbuildings(publishedby
the Institution of Electrical Engineers).
• CataloguesandproductleaetsofthisCompanyorliterature
which may be obtained by specific request to the Company.
To Next Page
