Need help?Do you have a question about the Elster Q.Sonic PLUS and is the answer not in the manual?
General| Type | Ultrasonic Flow Meter |
|---|---|
| Category | Measuring Instruments |
| Measurement Principle | Ultrasonic transit time |
| Flow Rate | Dependent on line size |
| Accuracy | ±0.5% of reading |
| Communication Interface | RS-485, Ethernet, Modbus TCP/IP, HART |
| Outputs | 4-20 mA, Pulse |
| Power Supply | 24 V DC |
| Protection Class | IP66/67 |
| Approvals | MID, OIML |
Outlines requirements for calibration by certified institutes for custody transfer applications.
Explains how ultrasonic pulses are used to measure gas velocity based on travel times across the pipe.
Guides on safely handling and installing the meter according to regulations and spool piece requirements.
Directs users to refer to specific documents for correct wiring procedures for the meter.
Advises on reading and comparing parameter settings using SonicExplorer software after installation.
Describes the interactive touch screen display and its seven touch areas for user interaction and navigation.
Guides users on accessing and interpreting general and path-specific diagnostic data for troubleshooting.
Explains how to view, filter, and clear error and warning messages to manage device status.
Procedures for collecting meter data for trend analysis and inspecting measured parameters like sample rate.
Instructions and precautions for replacing parts like sensors and transducers, with safety considerations.
Specific steps and warnings for replacing the ultrasonic transducers, including depressurization requirements.
Steps to check software versions and checksums for meter components to ensure integrity.
To Next Page
