Elster Q.Sonic PLUS - MID Calibration and Sealing

MID Requirements
12
Page 64 of 68
Operation and Maintenance
UFM Series 6
Q.Sonic-plus
12.3 Sealing
An MID compliant meter shall be sealed.  See Chapter 5.7 Sealing (p.26)
for more information.
12.4 Calibration
An MID compliant meter is accompanied by a copy of the EC Declaration of
Conformity stating compliance with Measuring Instruments Directive
2004/22/EC
*)
Annex MI-002, based on:
 EC-Type examination certificate T10335 according MID Annex B
and
 a certificate of conformity from a Notified Body according to MID
Annex F.
*)
New European Directive valid from 20.04.2016: 2014/32/EU
12.5 Installation Requirements
Special attention needs to be taken so that the UFM Series 6 meter and its
in- and outlet spools are mounted according to EC examination Certificate
T10335 (last valid version).
Note that parameters stated in certificate T10335 may indicate a limit or
limits of a range. The values and ranges applicable to your flow meter may
be different.
The UFM needs to be powered by an Uninterruptible Power Supply (UPS).
 Please also refer to Chapter 6 Installation and Commissioning (p.29).