ELTEX TAU-36.IP - Page 170

_________________________________________________________________________________
_________________________________________________________________________________
170 Universal Network Terminal TAU-72.IP/TAU-36.IP
show hw
The command is intended for viewing hardware status.
Syntax.
show hw
Parameters
Command contains no arguments.
Privilegy
none
Command mode
EXEC
Example
tau-72> show hw
Vpower 11
Temp1 48, Temp2 45, Temp3 43, Temp4 43
SFP0: ST(0x7)- inserted 1, TxFault 1, LOS 1, TxDis 0
SFP0: Temp 65535, Power 65535, Cur 65535, ptx 65535, prx 65535
show switch
The command is intended for viewing switch ports status.
Syntax.
show switch
Parameters
Command contains no arguments.
Privilegy
none
Command mode
EXEC
Example
tau-72> show switch
Port 0:
Link: off
Duplex: half
Speed: 0Mbps
Port 1:
Link: on
Duplex: full
Speed: 1000Mbps
SFP 0:
Link: off
Duplex: half
Speed: 0Mbps
CPU:
Link: on
Duplex: full
Speed: 1000Mbps