11
4.1 Charging
The Hub will not turn on while it is charging. It takes approximately two hours to
fully charge the Hub, although this can vary depending on your charging set up.
A full charge lasts approximately five 30 minute sessions. Only use the Charging
Cable provided in the box.
Charge immediately after finishing your pumping session if low battery isindicated.
Tip: Press the Mode button when the Hub is o; the Intensity Lights will show
how much battery is left.
Tip: Close the Charging Port before use to ensure the Hub is as discreet as possible.
4.3 Cleaning
Before first use
Elvie Stride 2 is not provided sterile. It must be cleaned and disinfected before first use.
Always disassemble the components before cleaning ordisinfecting.
Non-washable components
The Hub, Cap, Tubes, Tube Splitter, Cover and Clip are non-washable components
and should be kept dry. They must not be microwaved. They can be wiped clean with
a clean paper towel or soft cloth after each use. The Hub should be disinfected with a
low-level disinfectant such as ethyl or isopropyl alcohol (70-90%), but should not be
submerged in water. If the tubes become moldy due to liquid entering them, discard
and replace immediately.
Washable components
*2 included with Elvie Stride 2 (Double) only
*Diaphragm
and Stopper
*Cup Front
*Breast Shield
Valve*
**Nipple Insert
(5 sizes included)
4.2 Disassembling Elvie Stride 2
Note: The Hub, Tubes and Cap
must be kept away from water.
1. Remove the Cap.
2. Pull the Breast Shield away
from the Cup Front and
remove the Nipple Insert.
3. Pull the Valve out of the
Cup Front, unplug the Stopper
and remove the Diaphragm.
To Next Page
Loading...
