Elvie Stride 2 - Page 12

12
Cleaning washable components that come into contact with milk, as soon as possible
after pumping, prevents the build-up of dry milk residue. Residue can cause the growth
of bacteria that may be harmful to you and your baby.
Cleaning (before first use and after every use)
Note: Do not place any of the parts directly in the kitchen sink for rinsing and washing.
Please use a dedicated wash basin and brush for infant feeding.
1. Rinse in cold, clear water.
2. Wash in warm water using mild dishwashing soap.
3. Rinse with cold, clear water for 10 to 15 seconds OR place on the top
shelf of the dishwasher.
Tip: Ensure the small hole in the top of the Cup Front is kept clean and clear
of milk build up at all times.
Disinfecting (before first use and subsequently once daily)
Cold water disinfection methods are known to preserve the longevity of your
washable parts. Alternatively, you can place parts in boiling water for 5 minutes.
Do not use microwave or steam disinfection methods.
Drying
Place parts on a clean surface and air dry completely beforeassembly.
4.4 Nipple Insert sizing
The Breast Shield and Nipple Insert creates a seal between your nipple and the pump
so it’s very important it fits well. Elvie Stride 2 (Single and Double) come with 28mm
Breast Shield(s). If required for a better fit there are 15mm, 17mm, 19mm, 21mm and
24mm Nipple Inserts included.
To check your nipple size, use our Nipple Sizing Tool, which is included. Ensure your
nipple is erect before measuring. Simply place your erect nipple in the hole so that it
fits snugly.
You will need to repeat this process separately for each nipple. Thisensures you have
the correct sizing on each side. You might find that your nipple could fit two dierent
sizes. If that’s the case, it’s a good idea to try pumping with each size to see which one
works best for you.
Note: Do not measure directly after pumping or feeding. Always measure before.